To Next Page

To Previous Page

0708.GB

F 4

4 EKS 310 maintenance checklist

Maintenance intervals

Standard = t WA BC

Chassis/

Super-

structure:

1.1 Check all load bearing items for damage t

1.2 Check screw connections t

1.3 Test the operator’s platform and check for damage t

1.4 Check that identification points, data plates and

warnings are legible and replace if necessary

Drive: 2.1 Lubricate the bearing between traction motor and

transmission

2.2 Check transmission for noise and leakage t

2.3 Change transmission oil t

Wheels: 3.1 Check wheels for wear and damage t

3.2 Check bearings and attachment t

Steering: 4.1 Test operation and setting of wheel setting display t

4.2 Check the distance between the guide rollers and the

rail guidance over the entire length of the rails. The play

between the two guide rollers and the rails (measured

over the axle) should be 0-5 mm. The rollers should not

jam.

Brake

system:

5.1 Test operation and settings t

5.2 Check the brake lining wear t

5.3 Check brake mechanism, adjust and lubricate if

necessary

5.4 Check brake lines, connections and brake fluid level t

5.5 Check brake fluid t

5.6 Replace brake fluide t