To Next Page

To Previous Page

C 3

0504.GB

2.1 Crane points

The crane points (1) are the eyes in the mast.

Crane points (2) are located on either side of the frame and crane points (3) are

located on the top mast bearing respectively. Suitable ring screws must be screwed

in at this point.

When lifting by crane, use the following crane points:

– Crane points for complete truck with mast assembled:

points (1) and (2) (for weight see data plate)

– Crane points for the basic truck:

points (2) and (3) (weight 1200 kg)

– Crane points incl. cab and load lifting device:

points (1) (weight 3000 kg)

2.2 Lifting the battery by crane

When lifting the battery with a crane attach suitable lifting gear to the four eyes of the

battery container (for weight see battery data plate).

For battery removal see Chapter D, Section 4.

2.3 Securing the Truck for Transport.

When transported on a lorry or a trailer the truck must be securely fastened down.

The lorry or trailer must have fastening rings.

Loading shall be carried out by staff especially trained for that purpose in accordance

with recommendations contained in Guidelines VDI 2700 and VDI 2703. In each case

correct measurements shall be determined and appropriate safety measures

adopted.

C 3