To Next Page

To Previous Page

0504.GB

D 2

2Battery types

The EKS 310 can be fitted with a range of battery types. All the batteries correspond

to DIN 43531-A. The following table indicates the capacities to show which

combinations can be used as standard:

The battery weights can be taken from the battery data plate.

The weight and dimensions of the battery have a considerable influence on the

operational safety of the truck. Battery equipment changes may only be made with

the agreement of the manufacturer.

3 Charging the battery

Park the truck securely (See Chapter E).

– Turn the key switch to "0" (Zero) and press the EMERGENCY DISCONNECT

switch.

– Fully open the battery panels.

Only connect and disconnect the battery connector and the socket when the mains

and charger are switched off.

– Disconnect the battery.

– If necessary, remove the insulating mat from the battery.

When charging, the top surfaces of the battery cells must be exposed to provide

sufficient ventilation. Do not place any metal objects on the battery. Before charging,

check all cables and plug connections for visible signs of damage.

– Connect the charger lead of the battery charger station with the battery connector.

– Switch on the charger.

– Charge the battery in accordance with the battery and charger station

manufacturers’ instructions.

It is essential to follow the safety regulations of the battery and charger station

manufacturers.

Battery type Truck type

48 V 3 E PzS 420 EKS 310k

48 V 4 E PzS 560 EKS 310