To Next Page

To Previous Page

C 1

0301.GB

C Transportation and commissioning

1 Transportation by crane

Only use lifting gear of adequate capacity

(loading weight = dead weight + battery weight; see truck identification plate).

Lifting points (1) are provided or loading the truck by means of crane gear. The lifting

points are covered by plastic covers that must be re-inserted after transport.

– Park the truck and render it safe

(see chapter E).

– Attach the crane gear to the lifting eye

(1).

The crane gear must be attached to the

lifting eye in such a manner that it

cannot slip!

The crane gear must be attached in

such a manner that it does not touch

any attachments during lifting.

2 Commissioning

The truck must only be operated on bat-

tery current! Cables connected to the

battery (trailing cables) must be less

than 6 m in length.

To prepare the truck for operation after delivery or transportation, the following ope-

rations must be performed:

– Check the equipment for completeness.

– If necessary, install the battery. Make sure that the battery cable is not damaged.

– Charge the battery (see chapter D).

– Put the truck into operation in the stipulated manner (see chapter E).

When the truck is parked, the surface of the tyres may flatten. The flattening will dis-

appear after the truck has been operated for a short time.

C 1