0301.GB
E 6
4.2 Driving, steering, braking
f
It is not admissible to stay on the vehicle during driving.
Emergency stop
– Push the emergency-off button (8).
All of the electrical functions are switched off.
Automatic braking
Releasing the control shaft causes automatic braking - the control shaft automatically
moves into the upper braking range (B).
f
If the control shaft moves to the braking position more slowly than normal, the cause
must be determined and eliminated. If necessary, the gas pressure spring must be
replaced.
Driving
m
Only drive with the hoods closed and properly locked.
– Start up the truck (see section 3).
The travelling speed can be controlled using the controller (2).
– Tilt the control shaft (11) into the driving range (F) and set the controller (2) to the
desired direction (V or R).
Steering
– Swivel the control shaft (11) to the left or the right.
m
In narrow bends, the control shaft protrudes beyond the truck contour!
0301.GB
E 6
4.2 Driving, steering, braking
f
It is not admissible to stay on the vehicle during driving.
Emergency stop
– Push the emergency-off button (8).
All of the electrical functions are switched off.
Automatic braking
Releasing the control shaft causes automatic braking - the control shaft automatically
moves into the upper braking range (B).
f
If the control shaft moves to the braking position more slowly than normal, the cause
must be determined and eliminated. If necessary, the gas pressure spring must be
replaced.
Driving
m
Only drive with the hoods closed and properly locked.
– Start up the truck (see section 3).
The travelling speed can be controlled using the controller (2).
– Tilt the control shaft (11) into the driving range (F) and set the controller (2) to the
desired direction (V or R).
Steering
– Swivel the control shaft (11) to the left or the right.
m
In narrow bends, the control shaft protrudes beyond the truck contour!
To Next Page
Loading...
