Jungheinrich EME 112 - Picking up and Setting down Loads

0301.GB
E 8
Accelerating on slopes
f
The load must face uphill!
The slope to be negotiated must not exceed 10 m in length:
– without load: 15%
– load of 600 kg: 6%
– load of 1200 kg: 3,5%
m
The truck must not be drived on slopes exceeding the specified values. Successive
slopes may only be negotiated after longer breaks.
4.3 Picking up and setting down loads
m
Before picking up a load, the driver must make sure that the load rests properly on its
pallet and that it does not exceed the maximum load capacity of the truck.
Picking up long loads crosswise is not permitted.
– Move the truck so that the load lifting device passes completely below the load.
A
The lifting and lowering speeds are preset.
Lifting
– Press the “Lift load lifting device” button (3) until the required lifting height has been
reached.
Lowering
– Press the “Lower load lifting device” button (4).
3 4
0301.GB
E 8
Accelerating on slopes
f
The load must face uphill!
The slope to be negotiated must not exceed 10 m in length:
– without load: 15%
– load of 600 kg: 6%
– load of 1200 kg: 3,5%
m
The truck must not be drived on slopes exceeding the specified values. Successive
slopes may only be negotiated after longer breaks.
4.3 Picking up and setting down loads
m
Before picking up a load, the driver must make sure that the load rests properly on its
pallet and that it does not exceed the maximum load capacity of the truck.
Picking up long loads crosswise is not permitted.
– Move the truck so that the load lifting device passes completely below the load.
A
The lifting and lowering speeds are preset.
Lifting
– Press the “Lift load lifting device” button (3) until the required lifting height has been
reached.
Lowering
– Press the “Lower load lifting device” button (4).
3 4