To Next Page

To Previous Page

0506.GB

10.2.1 Clamping ring tool

The clamping ring tool is used to push on a clamping ring to increase the contact pres-

sure of the hose connection on the plugs' hose couplings and to loosen it again.

10.3 Filter element

For safety reasons a filter element (ident no.: 50307282) can be fitted into the batte-

ry's main supply pipe for supplying battery water. This filter element has a maximum

passage cross-section of 100 to 300 µm and is designed as a bag filter.

10.4 Sealing coupler

The water is supplied to the water refilling systems (Aquamatic/BFS) through a cen-

tral supply pipe. This is connected to the water supply system at the battery charging

station by means of a sealing coupler system. On the battery side a closing nipple

(ident no.: 50219538) is mounted and the customer must place a sealing coupler

construction on the water supply side (obtainable under ident. no.: 50219537).

11. Functional data

PS - self-sealing pressure: Aquamatic > 1.2 bars

BFS system none

D - rate of flow in the opened valve when the pressure is 0.1 bars: 350 ml/min

D1 - maximum permissible leakage rate in the closed valve when the pressure is at

0.1 bars: 2 ml/min

T - permissible temperature range: 0° C to a maximum of 65° C

Pa - operating pressure range: 0.2 to 0.6 bars in the Aquamatic system and

operating pressure range: 0.3 to 1.8 bars in the BFS system.