Jungheinrich HC 110 Operator's Manual

1004.GB
C 2
2 Securing the truck during transport
F
The truck must be securely fastened when transported on a lorry or a trailer. The
lorry / trailer must have fastening rings.
– To secure the truck attach the tensioning belt to the strap points (2) and the push
handles (3) and attach it to the fastening rings.
– Tighten the tensioning belt with the tensioner.
M
Loading must be carried out by specially trained staff in accordance with
recommendations contained in Guidelines VDI 2700 and VDI 2703. In each case
correct measurements must be made and appropriate safety measures adopted.
3 Using the truck for the first time
F
In order to disconnect the power supply immediately in an emergency, the battery
connector must be connected to the truck’s Emergency Disconnect. The truck must
not be operated without the emergency disconnect.
To prepare the truck after delivery or after transport, proceed as follows:
– Make sure the truck’s equipment is complete and in a satisfactory condition.
– Install battery (where required). Do not damage battery cable. (see Chapter D).
– Charge the battery (see Chapter D).
– Start up the truck as indicated. (see Chapter E).
Z
When the truck is parked the surface of the tyres will flatten. The flattening will
disappear after a short period of operation.
2
3
1004.GB
C 2
2 Securing the truck during transport
F
The truck must be securely fastened when transported on a lorry or a trailer. The
lorry / trailer must have fastening rings.
– To secure the truck attach the tensioning belt to the strap points (2) and the push
handles (3) and attach it to the fastening rings.
– Tighten the tensioning belt with the tensioner.
M
Loading must be carried out by specially trained staff in accordance with
recommendations contained in Guidelines VDI 2700 and VDI 2703. In each case
correct measurements must be made and appropriate safety measures adopted.
3 Using the truck for the first time
F
In order to disconnect the power supply immediately in an emergency, the battery
connector must be connected to the truck’s Emergency Disconnect. The truck must
not be operated without the emergency disconnect.
To prepare the truck after delivery or after transport, proceed as follows:
– Make sure the truck’s equipment is complete and in a satisfactory condition.
– Install battery (where required). Do not damage battery cable. (see Chapter D).
– Charge the battery (see Chapter D).
– Start up the truck as indicated. (see Chapter E).
Z
When the truck is parked the surface of the tyres will flatten. The flattening will
disappear after a short period of operation.
2
3

Jungheinrich HC 110 Specifications

General

Brand	Jungheinrich
Model	HC 110
Category	Forklifts
Language	English