Jungheinrich HC 110 Operator's Manual

E 7
1004.GB
Brakes
F
The braking pattern of the truck depends largely on the ground conditions. The driver
must take this into account.
The truck can brake in two different ways:
– Manually (by pulling or pushing against the direction of movement)
– Brake pedal (parking brake only)
Travelling on inclines
M
Loads must always be carried at that end of the truck facing uphill.
4.3 Lifting and depositing loads
Z
Before lifting a load, the driver must ensure that it is correctly palletised and that the
capacity of the truck is not exceeded.
– Enter the truck and the forks as far as possible underneath the load unit.
Lifting
– Press the “Raise Load Forks” button ((22)
until the required lifting height has been
reached.
Lowering
– Press the “Lower Load Forks” button (21)
until the required lifting height has been
reached.
4.4 Parking the truck safely
When you leave the truck it must be securely parked even if you only intend to leave
it for a short time.
F
Do not park the truck on a slope. The forks must always be lowered to the ground.
– Lower the forks.
– Set the key (23) to the vertical position and remove it.
– Apply the brake pedal (26).
– To release the brake step on the brake release mechanism (24 or 26).
2122
23
24
25
26
E 7
1004.GB
Brakes
F
The braking pattern of the truck depends largely on the ground conditions. The driver
must take this into account.
The truck can brake in two different ways:
– Manually (by pulling or pushing against the direction of movement)
– Brake pedal (parking brake only)
Travelling on inclines
M
Loads must always be carried at that end of the truck facing uphill.
4.3 Lifting and depositing loads
Z
Before lifting a load, the driver must ensure that it is correctly palletised and that the
capacity of the truck is not exceeded.
– Enter the truck and the forks as far as possible underneath the load unit.
Lifting
– Press the “Raise Load Forks” button ((22)
until the required lifting height has been
reached.
Lowering
– Press the “Lower Load Forks” button (21)
until the required lifting height has been
reached.
4.4 Parking the truck safely
When you leave the truck it must be securely parked even if you only intend to leave
it for a short time.
F
Do not park the truck on a slope. The forks must always be lowered to the ground.
– Lower the forks.
– Set the key (23) to the vertical position and remove it.
– Apply the brake pedal (26).
– To release the brake step on the brake release mechanism (24 or 26).
2122
23
24
25
26

Jungheinrich HC 110 Specifications

General

Brand	Jungheinrich
Model	HC 110
Category	Forklifts
Language	English