Jungheinrich HC 110 - 4 Charging the battery

1004.GB
E 4
3 Starting up the truck
F
Before the truck can be started, operated or a load lifted, the driver must ensure that
there is nobody within the hazardous area.
Checks and operations to be performed before starting daily work
– Visually inspect the entire truck (in particular wheels and load handler) for obvious
damage.
– Visually inspect the battery attachment and cable connections
Switching on the truck
– Make sure the battery is connected (12).
– Check if charging connector has been removed, if necessary terminate charging
(see chapter D).
– Insert the key in the key switch (14) and turn it as far right as it will go.
Z
The battery discharge indicator (13) shows the current battery charge status.
– Test lifting (15) and lowering (16) by applying the control lever.
– Test the brakes (see section 4.2)
The truck is now operational.
12 13 14 15 16
1004.GB
E 4
3 Starting up the truck
F
Before the truck can be started, operated or a load lifted, the driver must ensure that
there is nobody within the hazardous area.
Checks and operations to be performed before starting daily work
– Visually inspect the entire truck (in particular wheels and load handler) for obvious
damage.
– Visually inspect the battery attachment and cable connections
Switching on the truck
– Make sure the battery is connected (12).
– Check if charging connector has been removed, if necessary terminate charging
(see chapter D).
– Insert the key in the key switch (14) and turn it as far right as it will go.
Z
The battery discharge indicator (13) shows the current battery charge status.
– Test lifting (15) and lowering (16) by applying the control lever.
– Test the brakes (see section 4.2)
The truck is now operational.
12 13 14 15 16