Jungheinrich HC 110 - Operation; 1 Safety Regulations for the Operation of Forklift Trucks

To Next Page

To Previous Page

1004.GB

E 8

4.5 Troubleshooting

This chapter allows the user to identify and rectify basic faults or the effects of

incorrect operation. When trying to locate a fault, proceed in the order shown in the

table.

If the fault cannot be rectified after carrying out the remedial procedure, notify the

manufacturer’s service organisation, as any further troubleshooting can only be

performed by specially trained and qualified service personnel.

Fault Probable Cause Action

Truck does not

start

– Battery connector not plugged

– Check battery plug and plug in

if necessary.

– Key switch set to OFF – Set key switch to "I"

– Battery still being charged – Disconnect the 230 volt

connection

– Battery charge too low – Check battery charge, charge

battery if necessary

– Battery not charging – Check charger, check battery

terminal connections

– Faulty fuse – Check fuses 2F1 and F1

Load cannot

be lifted

– Truck not operational – Carry out all remedial actions

listed under “Truck does not

start”.

– Hydraulic oil level too low – Check the hydraulic oil level

– Faulty fuse – Check fuse F1

– Load is too heavy – Note maximum capacity (see

data plate)

– Charge capacity below 40% – Charging the battery