LS-Support-Interfaces@jungheinrich.de
5. Start-up
After the device has been connected to the voltage source and the service slot has been closed again,
the device can be put into operation.
When the device is switched on for the first time, it automatically starts the start-up wizard of the oper-
ating system.
To do this, press the power-on button on the front for approx. 1 second.
5.1 Front Keys
The front keys can be individually configured in the Configuration Center. They have the following
functions ex-factory:
Power button.
To avoid unintentional actuation, press the button for at least 1
second.
Shift key (Function) for the second keyboard level.
The key is pressed, then the corresponding function key can be
pressed.
Standard:
Cancellation of the respective action (ESC)
FN:
Decrease screen brightness
Standard:
Navigation up (arrow up)
FN:
Increase screen brightness
Standard:
Navigation down (arrow down)
FN:
Decrease volume
Standard:
Confirmation of the respective action (Enter)
FN:
Increase volume
Except for the FN key and the power button, all keys can be individually configured via the Configuration
Center.
The assignment of the front keys in the BIOS differs from that in the operating system. See chapter
8.
To Next Page
Loading...
Need help?
General
