2. General Description
2.1 Intended Use
The device was specifically developed for use on forklift trucks in logistics and industrial environments.
A further application area is in the production environment where the device is used for stationary vis-
ualisation, control and operating/machine data collection.
The device must be operated and stored under the following conditions:
Temperature during operation -30°C to +50°C
Temperature during storage -40°C to +80°C
Air humidity in operation and storage 10% to 95% without condensate.
The device is protected against dust and jets of water in accordance with protection rating IP65.
Use in areas where there is a risk of explosion is prohibited.
The operator alone shall be responsible for ensuring that all operator obligations are observed and for
complying with any technical or statutory amendments that may arise.
Installation, commissioning and operation may only be performed by qualified and trained personnel.
Intervention by the user is required only for performing the actions described in this document.
Should any further modifications be required, it is necessary to consult either with the manufacturer
directly or with service personnel authorised by the manufacturer.
The device must be de-energised during service work. Appropriate measures must be taken to prevent
electrostatic discharges on components.
The device is only to be assembled, installed and operated within the permissible specifications.
Use in non-specified environments is prohibited.
2.2 Improper use
Operation other than or beyond that described for the device shall be deemed improper use. The device
is not allowed to be used to control vehicles or for applications for which further approvals beyond the
manufacturer's declaration are necessary, e.g. applications with explosion hazard, medical technology
and shipping industry. The device must not be put into operation in the case of transport damage or
nonconformity with the specifications and must be taken out of operation in the case of changing con-
ditions. In the case of improper use, ADS-TEC shall not accept responsibility or liability for injury or
damage that is directly or indirectly attributable to the handling of the device. If the device is opened by
an unauthorised person, the user may be subject to hazards and the warranty is invalidated. Should
the device have evident signs of damages caused, e.g., by improper operation or storage conditions or
due to improper use or handling, it must be shut down immediately. Ensure that it is secured against
being started up accidentally. The device can be damaged as a result of unauthorised mechanical
modifications. Make sure that the device is not drilled, chiselled or perforated and its exterior shape and
design is not modified in any way!
To Next Page
Loading...
Need help?
General
