Jungheinrich WMT 21 Series Service Manual

Page 33
v1.1
24.05.2023
LS-Support-Interfaces@jungheinrich.de
Activating/deactivating interfaces
The setup menu allows you to configure performance, hardware and interface properties. The settings
are adjusted to the device ex works and should only be changed by experienced users.
The following menu paths can be used to activate / deactivate selected interfaces:
Interface
Menu
Default
PXE-Boot
System Settings → Network Stack Configuration
Boot → Network Stack Driver Support
Disabled
Disabled
Front USB
System Settings → Front USB
Enabled
3 USB 3.0
System Settings → M.2 Slot 3 USB3
Enabled

Jungheinrich WMT 21 Series Specifications

General

Brand	Jungheinrich
Model	WMT 21 Series
Category	Touch terminals
Language	English