Juniper JUNOS OS 10.4 - RELEASE NOTES - Configuration

•
On SRX Series devices, the show system storage partitions command now displays the
partitioning scheme details on SRX Series devices.
•
Example 1:
show system storage partitions (dual root partitioning)
user@host# show system storage partitions
Boot Media: internal (da0)
Active Partition: da0s2a
Backup Partition: da0s1a
Currently booted from: active (da0s2a)
Partitions Information:
Partition Size Mountpoint
s1a 293M altroot
s2a 293M /
s3e 24M /config
s3f 342M /var
s4a 30M recovery
•
Example 2:
show system storage partitions (single root partitioning)
user@host# show system storage partitions
Boot Media: internal (da0)
Partitions Information:
Partition Size Mountpoint
s1a 898M /
s1e 24M /config
s1f 61M /var
show system storage
partitions (USB)
•
Example 3:
show system storage partitions (usb)
user@host# show system storage partitions
Boot Media: usb (da1)
Active Partition: da1s1a
Backup Partition: da1s2a
Currently booted from: active (da1s1a)
Partitions Information:
Partition Size Mountpoint
s1a 293M /
s2a 293M altroot
s3e 24M /config
s3f 342M /var
s4a 30M recovery
Configuration
•
J Series devices no longer allow a configuration in which a tunnel's source or destination
address falls under the subnet of the same logical interface’s address.
Copyright © 2010, Juniper Networks, Inc.114
JUNOS OS 10.4 Release Notes