•
Remove multilink-max-classes from [ls-0/0/0 unit 0], if configured.
•
Remove link-layer-overhead from [ls-0/0/0 unit 0], if configured.
•
If the LFI forwarding class is mapped to no-fragmentation in fragmentation-map and
the configuration hierarchy is enabled on lsq-0/0/0 in Junos OS Release 10.4, then
•
Add interleave-fragments under [ls-0/0/0 unit 0]
•
Adjust classifier configured for LFI on lsq-0/0/0 under [class-of-service] to classify
packets to Q2
If the aforementioned instructions are not followed, the bundle will be incorrectly
processed.
•
On SRX Series devices, as per the new behavior, on configuring identical IPs on a single
interface users no longer see a warning message; instead, a syslog message appears.
•
On SRX5600 devices, when an authentication policy is being matched by traffic,
deleting the authentication configuration from this policy might cause a crash.
Installation
•
On SRX100, SRX210, SRX220, SRX240, and SRX650 devices, support for USB
auto-installation is added. This feature simplifies the upgrading of Junos OS images
in cases where there is no console access to an SRX Series device located at a remote
site. This feature allows you to upgrade the Junos OS image with minimum configuration
effort by simply inserting a USB flash drive into the USB port of the SRX Series device
and performing a few simple steps. This feature can also be used for reformatting boot
devices and recovering SRX Series devices after a boot media corruption.
Integrated Convergence Services
•
On SRX210 device with Integrated Convergence Services, users cannot clone the
existing configuration for Integrated Convergence Services. The clone option has been
removed from all Convergence Services pages on J-Web.
Interfaces and Routing
•
On SRX100, SRX210, SRX220, SRX240, and SRX650 devices, support for USB
auto-installation is added.
•
On SRX Series devices, to minimize the size of system logs, the default logging level
in the factory configuration has been changed from any any to any critical.
•
On SRX3000 and SRX5000 line devices, the set protocols bgp family inet flow and set
routing-options flow CLI statements are no longer available, because BGP flow spec
functionality is not supported on these devices.
•
On SRX100, SRX210, SRX240, and SRX650 devices, the autoinstallation functionality
on an interface enables a DHCP client on the interface and remains in the DHCP client
mode. In previous releases, after a certain period, the interface changed from being a
DHCP client to a DHCP server.
117Copyright © 2010, Juniper Networks, Inc.
Changes in Default Behavior and Syntax in Junos OS Release 10.4 for SRX Series Services Gateways and J Series Services Routers
To Next Page
Loading...