Juniper JUNOS OS 10.4 - RELEASE NOTES - Command-Line Interface (CLI)

•
Group VPN is not supported.
•
Sampling features like J-FLow, packet capture, and port mirror on the reth interface
are not supported.
•
IDP is not supported for active/active chassis cluster. IDP is supported for
active/backup chassis cluster in Junos OS Release 10.2R2 and later.
•
Switching is not supported in chassis cluster mode.
•
Any packet-based services like MPLS and CLNS are not supported.
•
lsq-0/0/0—Link services Multilink Point-to-Point Protocol (MLPPP), Multilink Frame
Relay (MLFR), and Compressed Real-Time Transport Protocol (CRTP) are not
supported.
•
gr-0/0/0—Generic routing encapsulation (GRE) and tunneling are not supported.
•
ip-0/0/0—IP-over-IP (IP-IP) encapsulation are not supported.
•
lt-0/0/0—CoS for real-time performance monitoring (RPM) are not supported.
•
PP0: PPPoE, PPPoEoA is not supported.
•
ISDN/WXC are not supported in standalone mode.
•
On SRX100, SRX210, SRX220, SRX240, and SRX650 devices, UTM is supported only
for active/backup chassis cluster configuration with both RG0 and RG1 active on the
same node. It is not supported for active/active chassis cluster configuration.
For other limitations in chassis cluster, see “Limitations of Chassis Clustering” in the Junos
OS Security Configuration Guide.
Command-Line Interface (CLI)
•
On SRX210 and SRX240 devices, J-Web crashes if more than nine users log in to the
device by using the CLI. The number of users allowed to access the device is limited
as follows:
•
For SRX210 devices: four CLI users and three J-Web users
•
For SRX240 devices: six CLI users and five J-Web users
•
On SRX210 devices with Integrated Convergence Services, TDM configuration change
might interrupt existing TDM calls. The voice calls do not work. Run the CLI restart rtmd
command after making a configuration change.
Copyright © 2010, Juniper Networks, Inc.134
JUNOS OS 10.4 Release Notes