System Hierarchy
•
On all SRX100, SRX210, SRX220, SRX240, and SRX650 devices, the following system
hierarchy CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
set system diag-port-authentication
IPv6 and MVPN CLI
•
On SRX1400, SRX3400, SRX3600, SRX5600, and SRX5800 devices, the following
multicast IPv6 and MVPN CLI commands are not supported. However, if you enter
these commands in the CLI editor, they will appear to succeed and will not display an
error message.
•
show pim interfaces inet6
•
show pim neighbors inet6
•
show pim source inet6
•
show pim rps inet6
•
show pim join inet6
•
show pim mvpn
•
show multicast next-hops inet6
•
show multicast rpf inet6
•
show multicast route inet6
•
show multicast scope inet6
•
show multicast pim-to-mld-proxy
•
show multicast statistics inet6
•
show multicast usage inet6
•
show msdp sa group group
•
set protocols pim interface interface family inet6
•
set protocols pim disable interface interface family inet6
•
set protocols pim family inet6
•
set protocols pim disable family inet6
•
set protocols pim apply-groups group disable family inet6
•
set protocols pim apply-groups group family inet6
•
set protocols pim apply-groups-except group disable family inet6
131Copyright © 2010, Juniper Networks, Inc.
Unsupported CLI
To Next Page
Loading...