•
Support for configuring shaping overhead—Support for CLI based configuration of
shaping overhead has been added to the PD-5-10XGE-SFPP Type 4 PIC.
•
Set bandwidth value on aggregated Ethernet interfaces—You can now set the
bandwidth value by using the bandwidth value statement at the [edit interfaces
aggregate-interface unit number] hierarchy level.
Additionally, the show interfaces aggregate-inteface extensive and the show interfaces
aggregate.logical-interface commands now show the bandwidth of the aggregate when
it is configured. Also, the SNMP OID ifSpeed/ifHighSpeed of the aggregate logical
interface shows the corresponding bandwidth, when it is configured. When it is not
configured, the command shows it as the sum of the bandwidths of the member links
of the aggregate, as before.
•
Network interfaces show command output (All platforms)—The output of the show
interfaces detail/extensive command now adds a table that shows complete (not
truncated) names of the forwarding classes associated with queues.
[Network Interfaces]
•
Negotiate IP address option removed—The negotiate IP address option is no longer
allowed in the MLFR and MFR encapsulations.
•
Hardware restrictions in the output of the show interfaces extensive command—When
using the show interfaces extensive command with a 100-Gigabit Ethernet PIC, the
“Filter statistics” section will not be displayed because the hardware does not include
those counters.
•
Increase in unit numbering for demux0 and pp0 interfaces—The unit numbering for
demux0 and pp0 interfaces has been increased to 1,073,741,823.
•
Show chassis environment cb command on MX80 routers—The show chassis
environment cb command is now available for the MX80 routers.
Junos OS XML API and Scripting
•
The jcs:load-configuration template now accepts the $commit-options parameter—The
jcs:load-configuration template, included in the import file junos.xsl, now accepts the
$commit-options parameter to customize the commit operation. The parameter must
be passed to the jcs:load-configuration template as a node-set.
The default value for $commit-options is null. Supported options are:
•
check—Check the correctness of the candidate configuration syntax, but do not
commit the changes.
•
force-synchronize—Force the commit on the other Routing Engine (ignore any
warnings).
•
log—Write the specified message to the commit log. This is identical to the CLI
configuration mode command commit comment.
•
synchronize—Synchronize the commit on both Routing Engines.
39Copyright © 2010, Juniper Networks, Inc.
Changes in Default Behavior and Syntax in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
To Next Page
Loading...