Juniper JUNOS OS 10.4 - RELEASE NOTES - Upgrade and Downgrade Instructions for Junos os Release 10.4 for M Series, MX Series, and T Series Routers

[Subscriber Access]
•
The Subscriber Access Configuration Guide incorrectly describes the authentication-order
statement as it is used for subscriber access management. When configuring the
authentication-order statement for subscriber access management, you must always
specify the radius method. Subscriber access management does not support the
password keyword (the default), and authentication fails when you do not specify an
authentication method.
[Subscriber Access]
User Interface and Configuration
•
The show system statistics bridge command displays system statistics on MX Series
routers. [System Basics Command Reference]
VPNs
•
In Chapter 19, Configuring VPLS of the VPNs Configuration Guide, an incorrect statement
that caused contradictory information about which platforms support LDP BGP
interworking has been removed. The M7i router was also omitted from the list of
supported platforms. The M7i router does support LDP BGP interworking.
[VPNs]
Related
Documentation
New Features in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
on page 6
•
• Changes in Default Behavior and Syntax in Junos OS Release 10.4 for M Series, MX
Series, and T Series Routers on page 37
• Issues in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers on page 48
• Upgrade and Downgrade Instructions for Junos OS Release 10.4 for M Series, MX Series,
and T Series Routers on page 70
• Upgrade and Downgrade Instructions for Junos OS Release 10.4 for M Series, MX Series,
and T Series Routers on page 70
Upgrade and Downgrade Instructions for Junos OS Release 10.4 for M Series, MX Series, and T
Series Routers
This section discusses the following topics:
•
Basic Procedure for Upgrading to Release 10.4 on page 71
•
Upgrading a Router with Redundant Routing Engines on page 73
•
Upgrading Juniper Network Routers Running Draft-Rosen Multicast VPN to Junos OS
Release 10.1 on page 73
•
Upgrading the Software for a Routing Matrix on page 75
•
Upgrading Using ISSU on page 76
•
Upgrading from Junos OS Release 9.2 or Earlier on a Router Enabled for Both PIM and
NSR on page 76
Copyright © 2010, Juniper Networks, Inc.70
JUNOS OS 10.4 Release Notes