This default TAG reservation can be configured to use an alternative tag number or
not to use VLAN tagging at all
Wireless LAN (WLAN)
•
While configuring the AX411 Access Point on your SRX Series devices, you must enter
the WLAN admin password using the set wlan admin-authentication password
command. This command prompts for the password and the password entered is
stored in encrypted form.
NOTE:
•
Without wlan config option enabled, the AX411 Access Points will be
managed with the default password.
•
Changing the wlan admin-authentication password when the wlan
subsystem option is disabled might result in mismanagement of Access
Points . You might have to power cycle the Access Points manually to
avoid this issue.
•
The SRX Series devices that are not using the AX411 Access Point can
optionally delete the wlan config option.
•
Accessing the AX411 Access Point through SSH is disabled by default. You can enable
the SSH access using the set wlan access-point < name > external system services
enable-ssh command.
Unsupported CLI
This section lists unsupported CLI statements and commands.
Accounting-Options Hierarchy
•
On SRX100, SRX210, SRX220, SRX240, SRX650, and all J Series devices, the accounting,
source-class, and destination-class statements in the [accounting-options] hierarchy
level are not supported.
AX411 Access Point Hierarchy
•
On SRX100 devices, there are CLI commands for wireless LAN configurations related
to the AX411 Access Point. However, at this time the SRX100 devices do not support
the AX411 Access Point.
Chassis Hierarchy
•
On SRX100, SRX210, SRX220, SRX240, SRX650, and all J Series devices, the following
chassis hierarchy CLI commands are not supported. However, if you enter these
commands in the CLI editor, they appear to succeed and do not display an error
message.
set chassis craft-lockout
set chassis routing-engine on-disk-failure
Copyright © 2010, Juniper Networks, Inc.124
JUNOS OS 10.4 Release Notes
To Next Page
Loading...