[Interfaces Command Reference]
•
Enhancement to show oam ethernet connectivity-fault-management commands—The
output of the show oam ethernet connectivity-fault-management mep-statistics, show
oam ethernet connectivity-fault-management interfaces, and show oam ethernet
connectivity-fault-management mep-database commands includes the following three
new fields: Out of sync 1DMs received, which displays the number of out-of-sync one-way
delay measurement packets received; Valid DMMs received, which displays the number
of valid two-way delay measurement request packets received, and Invalid DMMs
received, which displays the number of invalid two-way delay measurement request
packets received.
[Interfaces Command Reference]
•
New command to clear ETH-DM delay-statistics (MX Series routers)—A new
command, clear oam ethernet connectivity-fault-management delay-statistics, enables
you to clear ITU-T Y.1731 Ethernet frame delay measurement (ETH-DM) delay-statistics
and ETH-DM frame counts. Use the maintenance-association
maintenance-association-name and maintenance-domain maintenance-domain-name
options to clear delay-statistics and frame counts for specific maintenance associations
and maintenance domains. You can also use the one-way and two-way options to
clear only one-way delay statistics or two-way delay statistics, respectively.
[Interfaces Command Reference]
•
Circuit Emulation (CE) interfaces firmware compatibility for ATM IMA on M7i, M10i,
M40e, M120, and M320 routers—Provides a Firmware mismatch syslog message and
a show interface command output message in the IMA Group state and IMA Link state
if the PIC's firmware is not compatible in Junos OS Release 10.0 and later releases.
NOTE: CE PICs require firmware version rom-ce-9.3.pbin or rom-ce-10.0.pbin
for ATM IMA functionality on M7i, M10i, M40e, M120, and M320 routers with
Junos OS Release 10.0R1.
CE PICs manufactured with the 560-028081.pbin firmware will produce the following
entry in /var/log/messages when Junos OS is upgraded to Release 10.0R1 or newer
releases:
Firmware mismatch. Need to upgrade PIC PROM Binary CPU firmware for IMA.
If you configure IMA with this combination of Junos OS and CE PIC firmware, the
following entry will be seen.
Firmware error. Need to upgrade PIC PROM Binary CPU firmware for IMA.
The show interfaces ce-fpc/pic/port command output will show the following:
Physical link is Down
IMA Group state : NE: Firmware Error
IMA Link state : Line: Firmware Error
The customer must contact JTAC for a PIC firmware upgrade to proceed with IMA.
[Interfaces Command Reference, System Log Messages Reference]
Copyright © 2010, Juniper Networks, Inc.38
JUNOS OS 10.4 Release Notes
To Next Page
Loading...