•
Port Troubleshooting page (Troubleshoot > Troubleshoot > Troubleshoot Port)
•
Static Routing page (Monitor > Routing > Route Information)
•
Support Information page (Maintain > Customer Support > Support Information)
•
View Events page (Monitor > Events and Alarms > View Events)
As a workaround, save the report and then open it.
[PR/433883]
•
In the J-Web interface, in the Port Security Configuration page, you are required to
configure action when you configure MAC limit even though configuring an action value
is not mandatory in the CLI. [PR/434836]
•
In the J-Web interface, in the OSPF Global Settings table in the OSPF Configuration
page, the Global Information table in the BGP Configuration page, or the Add Interface
window in the LACP Configuration page, if you try to change the position of columns
using the drag-and-drop method, only the column header moves to the new position
instead of the entire column. [PR/465030]
•
If a large number of static routes are configured and if you have navigated to pages
other than page 1 in the Route Information table in the J-Web interface (Monitor >
Routing > Route Information), changing the RouteTable to query other routes refreshes
the page but does not return to page 1. For example, if you run a query from page 3 and
the new query returns very few results, the Results table continues to display page 3
and shows no results. To view the results, navigate to page 1 manually. [PR/476338]
•
In the J-Web interface, the dashboard does not display the uplink ports or uplink module
ports unless transceivers are plugged into the ports. [PR/477549]
•
The J-Web interface Static Routing page might not display details on entries registered
in the routing table. [PR/483885]
•
If you try to commit a candidate configuration in the CLI using the Point and Click CLI
in the J-Web interface, an error is displayed on the configuration page. [PR/514771]
•
In the J-Web interface, the Software Upload and Install Package option might not display
a warning message when there are pending changes to be committed. [PR/514853]
•
On EX4500 switches, the J-Web interface might display the following as valid options
although these options are not supported on EX4500 switches:
•
DHCP snooping in the Edit Port Role window in the Ports Configuration page
•
Input filter association in the VLAN Configuration page
[PR/525671]
•
When you use an https connection in the Microsoft Internet Explorer browser to save
a report from the following pages in the J-Web interface, the error message “Internet
Explorer was not able to open the Internet site” is displayed:
•
Files page (Maintain > Files)
•
History page (Maintain > Config Management > History)
187Copyright © 2010, Juniper Networks, Inc.
Outstanding Issues in Junos OS Release 10.4 for EX Series Switches
To Next Page
Loading...