can configure a medium type (medium type) and protocol type (tunnel tunnel-type)
for the tunnel, only the default values of ipv4 and l2tp are supported in this release.
Include the identification name statement to configure an assignment ID for the tunnel.
Include the max-sessions number statement to configure the maximum number of
sessions permitted for the tunnel. Include the secret password statement to configure
a cleartext password for authentication by the remote tunnel endpoint (LNS). Finally,
you can configure a logical system and routing instance for the tunnel by including the
logical-system logical-system-name and routing-instance routing-instance-name
statements.
The following table shows the RADIUS attributes that are now supported for defining
a tunnel.
DescriptionAttribute Name
Attribute
Number
•
The tunneling protocol to use (in the case of a tunnel
initiator) or the tunneling protocol already in use (in
the case of a tunnel terminator).
•
Only L2TP tunnels are currently supported.
Tunnel-Type64
•
Transport medium to use when creating a tunnel for
protocols that can operate over multiple transports.
•
Only IPv4 is currently supported.
Tunnel-Medium-Type65
Address of the initiator end of the tunnel.Tunnel-Client-Endpoint66
Address of the server end of the tunnel.Tunnel-Server-Endpoint67
Password used to authenticate to a remote server.Tunnel-Password69
Indicates to the tunnel initiator the particular tunnel to
which a session is assigned.
Tunnel-Assignment -Id82
•
If more than one set of tunneling attributes is returned
by the RADIUS server to the tunnel initiator, this
attribute is included in each set to indicate the relative
preference assigned to each tunnel.
•
Included in the Tunnel-Link-Start, the
Tunnel-Link-Reject, and the Tunnel-Link-Stop packets
(LAC only).
Tunnel-Preference83
Name used by the tunnel initiator during the
authentication phase of tunnel establishment.
Tunnel-Client-Auth-Id90
Name used by the tunnel terminator during the
authentication phase of tunnel establishment.
Tunnel-Server-Auth-Id91
The following table shows the RADIUS VSAs that are now supported for defining a
tunnel.
ValueDescriptionAttribute Name
Attribute
Number
string:
tunnel-virtual-router
Virtual router name for tunnel
connection.
Tunnel-Virtual-Router26-8
27Copyright © 2010, Juniper Networks, Inc.
New Features in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
To Next Page
Loading...