•
During a graceful Routing Engine switchover, the traffic control profile might not be
applied on the interfaces. As a workaround, deactivate and reactivate class of service.
[PR/533862: This issue has been resolved.]
•
When per-unit-scheduler is applied under the interfaces hierarchy level, and shaping
rate is applied under the class-of-service interface hierarchy level in the same commit
operation, port shaping rate does not work and the total logical interface transmitted
byte rate exceeds the physical interface shaping rate. As a workaround, configure
shaping-rate within a traffic-control-profile and apply that to an interface, or deactivate
and activate shaping-rate using the class-of-service interface interface-name shaping-rate
command. [PR/539590: This issue has been resolved.]
•
Under certain conditions, the class of service configuration might not take effect on
an IQ2 PIC. [PR/541814: This issue has been resolved.]
•
When the rate-limit option is configured on a physical interface on IQ2 PICs, the show
interface queue command might not display the RL-dropped counters. [PR/547218:
This issue has been resolved.]
•
The egress rate limit over a logical interface may drop large packets. [PR/547506: This
issue has been resolved.]
•
In Junos OS Release 10.2 and later, the cosd process might crash while a configured
commit is processed, as this process accesses a memory location that has already
been freed. However, this issue is encountered rarely. [PR/548367: This issue has been
resolved.]
Forwarding and Sampling
•
Port mirroring does not work under the bridge-domain forwarding-option filter.
[PR/529272: This issue has been resolved.]
•
The policer counter might be missing in the SNMP walk. Reboot the router to solve this
problem. [PR/535715: This issue has been resolved.]
•
When logical systems are configured, the show bridge-domains command might time
out and return the following error message: “error: timeout communicating with
l2-learning daemon.” [PR/536604: This issue has been resolved.]
•
A scheduler is associated with a forwarding class, and when a forwarding class is
mapped to a different queue, the associated scheduler is not applied to the new queue.
[PR/540568: This issue has been resolved.]
•
In Junos OS Release 10.2, the Routing Engine-based sampling might not work if the
routing table inet.0 has a route for 128.0.0.1. The issue occurs when this route points
to an external interface. [PR/540891: This issue has been resolved.]
•
A GRE interface might experience an incoming packet loss if a firewall filter is configured
on the forwarding table. [PR/541901: This issue has been resolved.]
Copyright © 2010, Juniper Networks, Inc.56
JUNOS OS 10.4 Release Notes
To Next Page
Loading...