Juniper QFX5200 User Manual

To install a power supply in a QFX5200 (see Figure 61 on page 134 and Figure 62 on page 134):
1. Aach the ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the
chassis.
2. Taking care not to touch power supply components, pins, leads, or solder connecons, remove the
power supply from its bag.
CAUTION: Verify that the direcon of the arrow on the power supply handle matches
the direcon of airow in the chassis. Ensure that each power supply you install in the
chassis has the same airow direcon. If you install power supplies with two dierent
airow direcons, Junos OS raises an alarm, and the status (ALM) LED blinks amber.
3. Using both hands, place the power supply in the power supply slot on the FRU panel of the switch
and slide it in unl it is fully seated and the locking lever slides into place.
Figure 61: Installing a Power Supply in a QFX5200-32C or a QFX5200-32C-L
Figure 62: Installing a Power Supply in a QFX5200-48Y
134

Juniper QFX5200 Specifications

General

Brand	Juniper
Model	QFX5200
Category	Switch
Language	English