Juniper SRX220

Table 29 on page 81 provides the list of tasks you need to perform before installing the
device on a wall.
Table 29: SRX220 Services Gateway Preinstallation Checklist for
Wall-Mount Installation
Additional InformationTask
“Site Preparation Checklist for the
SRX220 Services Gateway” on page 27
Verify that the site meets the requirements.
“Unpacking the SRX220 Services
Gateway” on page 75
Remove the services gateway chassis from the
shipping box.
Verify that you have the following parts available in
your wall-mounting kit to mount the SRX220 Services
Gateway on a wall:
•
Wall-mounting brackets
•
Screws
NOTE: The wall-mounting kit is not shipped with the device and must be
ordered separately.
Related
Documentation
• Site Preparation Checklist for the SRX220 Services Gateway on page 27
• Unpacking the SRX220 Services Gateway on page 75
• Preparing the SRX220 Services Gateway for Rack-Mount Installation on page 79
81Copyright © 2012, Juniper Networks, Inc.
Chapter 11: Installing the Mounting Hardware