Access the Device 19
Figure 7: DB-9 Adapter
2. Plug the male end of the RJ-45 CAT5 serial cable into the Console port on the
SSG 20. (Be sure that the other end of the CAT5 cable is inserted properly and
secured in the DB-9 adapter.)
3. Launch a serial terminal-emulation program on your workstation. The required
settings to launch a console session with the devices are as follows:
Baud rate: 9600
Parity: None
Data bits: 8
Stop bit: 1
Flow Control: None
4. If you have not yet changed the default user name and password, enter
netscreen in both the login and password prompts. (Use lowercase letters only.
The login and password fields are both case-sensitive.)
For information on how to configure the device with the CLI commands, see
the Concepts and Examples Reference Guide for ScreenOS 5.4.0.
5. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To remove the timeout, enter
set console timeout 0.
Using the WebUI
To use the WebUI, you must initially be on the same subnetwork as the device. To
access the device with the WebUI, perform the following steps:
1. Connect your workstation to the 0/2 - 0/4 port (bgroup0 interface in the Trust
zone) on the device.
2. Ensure that your workstation is configured for DHCP or is statically configured
with an IP address in the 192.168.1.0/24 subnet.
3. Launch your browser, enter the IP address for the bgroup0 interface (the default
IP address is 192.168.1.1/24), then press Enter.
RJ-45 Jack
DB-9 adapter
RJ-45 cable
To Next Page
Loading...
