Juniper SSG 20 - ADSL2;2+ Interface Window

SSG 20 Hardware Installation and Configuration Guide
IV 
5. ADSL2/2+ Interface Window
If you have the ADSL2/2+ mini PIM installed on your device, the following window
is displayed. After you have entered the necessary information, click Next.
Figure 4: ADSL2/2+ Interface Configuration Window
Table 2:
If you do not know what these settings are, please refer to the Common Settings for
Service Providers document that came with the service provider device.
NOTE: If you have two ADSL2/2+ mini PIMs installed on your device and you select the
Multi-link option, you will see two Physical Layer tabs.
Field Description
Information from Service Provider:
VPI/VCI VPI/VCI values to identify the permanent virtual circuit.
Multiplexing Method ATM multiplexing method (LLC is the default).
RFC1483 Protocol Mode Protocol Mode setting.
Operating Mode Operating mode for the physical line (auto is the default)
IP configuration settings
 Select Dynamic IP via DHCP to enable the device to receive an
IP address for ADSL interface from an ISP.
 Select Dynamic IP via PPPoA to enable the device to act as a
PPPoA client. Enter the Username and Password assigned by the
service provider.
 Select Dynamic IP via PPPoE to enable the device to act as a
PPPoE client. Enter the Username and Password assigned by the
service provider.
 Select Static IP to assign a unique and fixed IP address to the
ADSL interface. Enter the interface IP address, Netmask, and
Gateway (the gateway address is the IP address of the router port
connected to the device).