Juniper SSG 20 - This Appendix Provides Detailed Information about the Initial Configuration Wizard; Rapid Deployment Window; Administrator Login Window; WLAN Access Point Window

SSG 20 Hardware Installation and Configuration Guide
II 
17. Confirmation Window on page XIX
1. Rapid Deployment Window
Table 1: Rapid Deployment Window
If your network uses NetScreen-Security Manager, you can use a Rapid Deployment
configlet to automatically configure the SSG device. Obtain a configlet from your
Security Manager administrator, select the Yes option, select the Load Configlet
from: option, browse to the file location, then click Next. The configlet sets up the
device for you.
If you want to bypass the configuration wizard and go directly to the WebUI, select
the last option, then click Next.
If you are not using a configlet to configure the device and want to use the
configuration wizard, select the first option, then click Next. The ICW welcome
screen appears. Click Next. The Administrator Login Window appears.
2. Administrator Login Window
Enter a new administrator login name and password, then Click Next.
Figure 1: Admin Login Window
3. WLAN Access Point Window
If you are using the device in the WORLD regulatory domain, you must choose a
country code. Select the appropriate option, then click Next.