Juniper SSG 20 - Basic Device Configuration; Changing the Root Admin Name and Password

Basic Device Configuration  23
Basic Device Configuration
This section describes optional configuration:
 “Changing the Root Admin Name and Password” on this page
 “Setting the Date and Time” on page 24
 “Administrative Access” on page 25
 “Management Services” on page 25
 “Host and Domain Name” on page 25
 “Default Route” on page 26
 “Management Interface Address” on page 26
 “Backup Untrust Interface Configuration” on page 26
Changing the Root Admin Name and Password
The root admin user has complete privileges to configure an SSG 20 device. We
recommend that you change the default root admin name (
netscreen) and
password (
netscreen) immediately.
WebUI
Configuration > Admin > Administrators > Edit (for the
netscreen
Administrator Name): Enter the following, then click OK:
Administrator Name:
Old Password:
New Password:
Confirm New Password:
CLI
set admin name name
set admin password pswd_str
save
NOTE:
Passwords are not displayed in the WebUI.