SSG 20 Hardware Installation and Configuration Guide
22 Default Device Settings
Table 6: Wireless and Logical Interface Bindings
You can change the default IP address on the bgroup0 interface to match the
addresses on your LAN and WLAN. For configuring a wireless interface to a bgroup,
see “Wireless Configuration” on page 27.
For addition bgroup information and examples, refer to the Concepts & Examples
ScreenOS Reference Guide.
There are no other default IP addresses configured on other Ethernet or wireless
interfaces on a device; you need to assign IP addresses to the other interfaces,
including the WAN interfaces.
SSG 20-WLAN Interface Zone
Wireless interface
Specifies a wireless interface, which is
configurable to operate on 2.4G and/or
5G radio.
wireless0/0 (default IP address is
192.168.2.1/24)
Trust
wireless0/1-0/3 Null
Logical Interfaces
Layer2 interface vlan1 specifies the logical interfaces
used for management and VPN traffic
termination while the device is in
Transparent mode.
N/A
Tunnel interfaces tunnel.n specifies a logical tunnel
interface. This interface is for VPN
traffic.
N/A
NOTE: The bgroup interface does not work in transparent mode when it contains a
wireless interface.
To Next Page
Loading...
