I
Appendix A
Initial Configuration Wizard
This appendix provides detailed information about the Initial Configuration Wizard
(ICW) for an SSG 20 device.
Using the Initial Configuration Wizard
After you have physically connected your device to the network, you can use the
ICW to configure the interfaces that are installed on your device.
This section describes the following ICW windows:
1. Rapid Deployment Window on page II
2. Administrator Login Window on page II
3. WLAN Access Point Window on page II
4. Physical Ethernet Interface Window on page III
5. ADSL2/2+ Interface Window on page IV
6. T1 Interface Windows on page V
7. E1 Interface Windows on page X
8. ISDN Interface Windows on page XII
9. V.92 Modem Interface Window on page XIV
10. Untrust Zone (Ethernet0/0 Interface) Window on page XV
11. DMZ Zone (Ethernet0/1 Interface) Window on page XVI
12. Trust Zone (Ethernet0/2 Interface) Window on page XVI
13. Wireless Interface (wireless0/0) in Trust Zone Window on page XVII
14. Interface Summary Window on page XVIII
15. Physical Ethernet DHCP Interface Window on page XVIII
16. Wireless DHCP Interface Window on page XIX
To Next Page
Loading...
