Juniper SSG 20 - DMZ Zone (Ethernet0;1 Interface) Window; Trust Zone (Ethernet0;2 Interface) Window

SSG 20 Hardware Installation and Configuration Guide
XVI 
11. DMZ Zone (Ethernet0/1 Interface) Window
The DMZ zone interface can have a static IP address or a dynamic IP address
assigned via DHCP. Insert the necessary information, then click Next.
Figure 16: Ethernet0/1 Interface Window
Table 14: Field Descriptions for the Ethernet0/1 Interface
12. Trust Zone (Ethernet0/2 Interface) Window
The Trust zone interface can have a static IP address or a dynamic IP address
assigned via DHCP. Insert the desired information, then click Next.
The default Interface IP is 192.168.1.1 with a netmask of 255.255.255.0 or 24.
Figure 17: Trust Zone (Ethernet0/2 Interface) Window
Table 15: Field Descriptions for the Trust Zone Interface
Field Description
Dynamic IP via DHCP Enables the device to receive an IP address for the DMZ zone
interface from an ISP.
Static IP Assigns a unique and fixed IP address to the DMZ zone interface.
Enter the DMZ zone interface IP and netmask.
Field Description
Dynamic IP via DHCP Enables the device to receive an IP address for the Trust zone
interface from an ISP.
Static IP Assigns a unique and fixed IP address to the Trust zone interface.
Enter the Trust Zone Interface IP and Netmask.