Juniper SSG 20 - Wireless Interface (Wireless0;0) in Trust Zone Window

 XVII
13. Wireless Interface (wireless0/0) in Trust Zone Window
You must set a Service Set Identifier (SSID) before the wireless0/0 interface can be
activated. For detailed instructions about configuring your wireless interface(s), see
the Concepts and Examples ScreenOS Reference Guide.
Figure 18: Wireless0/0 Interface Window
Table 16: Field Descriptions for Wireless0/0 Interface
After you have configured the WAN interfaces with, you will see the Interface
Summary Window. Check your interface configuration, then click Next when ready
to proceed. The Physical Ethernet DHCP Interface Window appears.
Field Description
Wlan Mode Sets the WLAN radio mode:
 802.11a
 802.11b/g
 802.11a/b/g
SSID Sets the SSID name.
Authentication and Encryption Sets the WLAN interface authentication and encryption.
 Open authentication, the default, allows anyone to access
the device. There is no encryption for this authentication
option.
 WPA Pre-Shared Key authentication sets the Pre-Shared Key
(PSK) or passphrase that must be entered when accessing
wireless connectivity. You can choose to enter a HEX or an
ASCII value for the PSK. A HEX PSK must be a 256-bit (64
text character) HEX value. An ASCII passphrase must be 8 to
63 text characters. You must select Temporal Key Integrity
Protocol (TKIP) or Advanced Encryption Standard (AES)
encryption type for this option, or select Auto to allow either
option.
Interface IP Sets the WLAN interface IP address.
Netmask Sets the WLAN interface netmask.