Juniper SSG 20 - Mini Physical Interface Module Port Descriptions

SSG 20 Hardware Installation and Configuration Guide
6  Front Panel
See “Connectors” on page III for the RJ-45 connector pinouts.
Mini Physical Interface Module Port Descriptions
Each mini physical interface module (PIM) supported on a device has the following
components:
 One cable connector port—Accepts a network media connector. Figure 3 shows
the available mini PIMs. You can install up to two mini PIMs in a device.
Figure 3: Mini PIMs on the SSG 20
 Two to three status LEDs—Indicates port status. Table 4 describes the meaning
of the LED states.
ISDN BRI
T1
V.92
E1
ADSL2/2+ Annex A
ADSL2/2+ Annex B
ADSL 2/2+
TX/RX
SYNC
ADSL 2/2+
TX/RX
SYNC
V.92
CD
TX/RX
T1
CD
L OOP BACK
ALARM
E1
CD
L OOP BACK
ALARM
ISDN (BRI )
Channel B2
Channel B1