JVC CA-S200 - Tape to Tape Recording (Dubbing)

Tape to Tape Recording (Dubbing)
' Tape to tape Recording from one tape to another is called dubbing.
dubbing: You can dub for the best possible quality.
Introduction Q To dub both sides of a tape, start from side A for both deck A and deck B, and press
REVERSE MODE so that the REVERSE MODE indicator lights up.
QO} Itis preferable that the type of tape Type I (Normal) or Type II (CrO,) you record from be
the same as the type you record onto.
Dubbing
Dubbing: 1, Insert a source cassette you want to copy from into deck A for playback.
Step by step 2. Insert a blank or erasable cassette you want to copy onto into deck B for recording.
3. Press REC PAUSE on deck B.
4. Press > (or <)) on deck B.
Recording starts. .
Q) To advance the leader tape, start recording first and wait about 10 seconds before
starting the deck A.
5. Press > (or <J) on deck A.
Deck A starts playing.
.
To stop any time during the dubbing process
Press M on both deck A and deck B.
How to use the DUBBING button
1. Insert a source cassette you want to copy from into deck A for playback.
2. Insert a blank or erasable cassette you want to copy onto into deck B for recording.
3. Press DUBBING.
Deck A and deck B will start simultaneously.
4. To stop:
¢ Press ™ on deck A. Recording on deck B will be paused by Rec Mute.
¢ Press mon deck B. Deck A and deck B will stop simultaneously.
© Dolby NR is inactive in dubbing mode regardless of the setting of DOLBY B NR.
The dubbed tape automatically contains the same processing as the source tape.
t= You cannot dub using the sound modes such as D.CLUB, HALL, STADIUM, etc.
Page 15