17
ENGLISH
Be sure to configure the following three
settings before use.
Charging the Battery Pack
1
Close the LCD monitor to turn off the
camcorder.
2
Attach the battery pack.battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camcorder
3
Connect the AC adapter.
•
The charge lamp blinks to indicate charging
has started.
•
When the lamp goes out, charging is
finished. Unplug the AC adapter (or
the power cord) from the AC outlet and
disconnect the AC adapter from the
camcorder.
L
To detach the battery pack
Slide and hold BATT. (Z step 2), then
remove the battery pack.
L
To check the remaining battery power
See page 19.
NOTES
•
You can also use the camcorder with just
the AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
Necessary Settings before Use
DC Jack
AC Adapter
To AC Outlet
(110V to 240V)
Charge
lamp
To Next Page
Loading...
Need help?
General