Basic operations
16
Press [AUDIO VOL +/–].
• You can also adjust the volume by turning the
[VOLUME] control on the main unit.
Press [FADE MUTING].
• Press [FADE MUTING] again or [AUDIO VOL +]
to restore the sound. The sound is also restored
when the main unit is turned off once and turned
on.
Bass: Press [BASS +/–].
Treble: Press [TREBLE +/–].
The K2 function is designed to provide natural
sound by improving the playback sound from low-
bit-rate digital sources.
The function compensates for sound waves dissi-
pated during digital recording compression to
approximate the original analog sound. Sound is
reproduced with more bits (24 bit) and a wider
range of frequency (128 kHz, 176.4 kHz or
192 kHz).
Press [K2] on the remote control or on
the main unit.
• When the K2 function is activated, the [K2] lamp
(button) on the main unit lights up.
• Each time you press [K2], the display changes
as follows.
- “K2 Mode 1”:
Plays back a digital source with non-com-
pressed sound signals (linear PCM).
- “K2 Mode 2”:
Plays back a digital source with compressed
sound signals (Dolby digital, DTS, MP3 or
WMA).
-“K2 OFF”:
Cancels the K2 function.
NOTE
• The initial setting is “K2 OFF”.
• If [K2] is pressed when the clear voice function,
headphone surround mode function, or 3D
PHONIC is activated, these functions are turned
off and the K2 function is activated.
• If [K2] is pressed when an AM/FM broadcast or
an analog audio device connected to the [LINE1
IN] or [LINE 2 IN] terminal is selected as the
source, “ANALOG SOURCE” is displayed in the
display window, and the K2 function is not acti-
vated. The K2 function is activated when a
loaded disc, a connected USB mass storage
class device, or a digital audio device connected
to the [LINE 3 DIGITAL IN] terminal is selected
as the source.
• The original range of frequency is automatically
detected and extended to a specific range.
When the original range is 32 kHz, 44.1 kHz or
48 kHz, the range is extended to 128 kHz,
176.4 kHz or 192 kHz respectively.
• This function is available when “PCM ONLY” is
selected for “DIGITAL AUDIO OUTPUT” (refer to
page 43). “NO OPERATION” appears in the dis-
play window and the K2 function cannot be used
when “DOLBY DIGITAL/PCM” or “STREAM/
PCM” is selected.
Adjusting the volume
Turning off the sound
temporarily
Adjusting the bass/treble
Enhancing the playback
sound (K2)
For the locations of the remote
control buttons, refer to page 14.
EX-A3[J_C].book Page 16 Wednesday, December 27, 2006 3:53 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
