102
OTHERS
Warnings and Responses
Warnings are displayed on the LCD monitor or the viewfinder if there was a mistaken operation, if the battery or tape is low, or if
there is a problem on the VTR.
In addition, if the tape or battery is low or the VTR has a problem, the tally lamp flashes (or lights) and an alarm is output from the
monitor speaker or PHONES jack.
MEMO
This device uses microcomputers. It may not operate properly if there is external static or interference. If this happens, turn the
power off and then on again.
Display Status Action
60/30 INHIBIT
CHANGE FRAME
RATE MENU
The FRAME RATE item is set to 50/25 or 24, and a tape re-
corded in 60/30 frame is played back or it is input into the
IEEE1394 port in VTR mode.
Sets the FRAME RATE item on the VIDEO FORMAT menu
screen to match the frames.
X See page 74.
50/25 INHIBIT
CHANGE FRAME
RATE MENU
The FRAME RATE item is set to 60/30 or 24, and a tape re-
corded in 50/25 frame or it is input into the IEEE1394 port
in VTR mode.
24 INHIBIT CHANGE
FRAME RATE MENU
The FRAME RATE item is set to 50/25 or 60/30, and a tape
recorded in 24 frame is played back or it is input into the
IEEE1394 port in VTR mode.
DV-60I INVALID!
DV-24P INVALID!
DV-24PA INVALID!
A tape recorded in DV-60I, DV-24P, or DV-24PA format
was played back or input into the IEEE1394 connector in
VTR mode on the E model.
The E model cannot play back tapes recorded in DV-60I,
DV-24P or DV-24PA format or input into the IEEE1394 con-
nector in VTR mode.
DV-50I INVALID!
DV-25P INVALID!
A tape recorded in DV-50I or DV-25P format was played
back or input into the IEEE1394 connector in VTR mode on
the U model.
The U model cannot play back tapes recorded in DV-50I or
DV-25P format or input into the IEEE1394 connector in
VTR mode.
HDV-SD60P
INVALID!
A tape recorded in HDV-SD60P format was played back or
input into IEEE1394 connector in VTR mode.
This device cannot play back or input an HDV-SD60P/
HDV-SD50P signal.
HDV-SD50P
INVALID!
A tape recorded in HDV-SD50P format was played back or
input into IEEE1394 connector in VTR mode.
INVALID TAPE! A computer data tape or a DVC PRO cassette was used. Use a MiniDV videocassette.
LP TAPE INVALID!* Tried to play back a tape recorded in LP mode. This device cannot record or play back in LP mode.
NO DV SIGNAL* DV signal was not input. Set the IEEE1394 switch to DV and input a DV signal.
NO HDV SIGNAL* HDV signal was not input. Set the IEEE1394 switch to HDV and input an HDV signal.
COPY INHIBIT* Tried to record a copyguarded signal. Cannot record a copyguarded signal.
REC INHIBIT* A tape that cannot be recorded (back switch is set to SAVE)
was inserted.
Set the switch on the back of the cassette tape to REC.
NO TAPE* No videocassette tape is inserted. Insert a cassette tape.
e_hd200.book Page 102 Friday, February 1, 2008 4:04 PM
To Next Page
Loading...
