JVC GY-HM790CHU - Setting Zebra Pattern

50
Shooting
Presetting the Time Code (continued)
䡵 Setting Time Code
1 Select [Main Menu] B [TC/UB] B [TC Preset] and press
the Set button (
R ). ( A Page 88)
The [TC Preset] screen appears.
Memo :
● When the [TC GENE.] switch is set to AREGENB, the
parameter is displayed as ARegenerationB and cannot be
selected.
● When [Main Menu] B [TC/UB] B [TCG Source] is set to
AExternalB, the parameter is displayed as AExternalB and
cannot be selected.
2 Set the time code (hour, minute, second, frame).
Use the cross-shaped button (
H I) to place the cursor at the
item to set, then the cross-shaped button (
JK) to change the
values.
Memo :
● Press the [USER2] button to reset each digit to A0B. The
cursor moves to the time digit (left).
3 Check the values and press the Set button (R).
● The time code is set and the screen returns to [TC/UB].
● To cancel the setting, press the [CANCEL] button.
4 Press the [MENU] button.
Returns to the normal screen.
Presetting the User’s Bit
You can add an 8-digit hexadecimal number as the user’s bit
to the recorded image.
1 Set [Main Menu] B [TC/UB] B [TCG Source] to
AInternalB. (A Page 88)
2 Select [Main Menu] B [TC/UB] B [UB Preset] and
press the Set button (
R). (A Page 88)
The [UB Preset] setting screen appears.
Memo :
● When the [TC GENE.] switch is set to AREGENB, the
parameter is displayed as ARegenerationB and cannot be
selected.
● When [Main Menu] B[TC/UB] B [TCG Source] is set to
AExternalB, the parameter is displayed as AExternalB and
cannot be selected.
Using the Internal Time
Code Generator
(continued)
[CANCEL] Button
[USER2] Button
[MENU] Button
Set Button (
R)
Cross-
shaped
button
(
JKH I)
1
[TC/UB] Menu Screen
Cursor
[TC Preset] Screen
(During drop frame)
During non-drop frame
[CANCEL] Button
[USER2] Button
[MENU] Button
Set Button (
R)
Cross-
shaped
button
(
JKH I)
1
[TC/UB] Menu Screen
Downloaded From VideoCamera-Manual.com Manuals