Setting User’s Bit without Opening the
Menu
.
Memo :
0
Settings cannot be made in the following cases.
0
When the [TC GENE.] switch is set to
“REGEN”.
0
Menu screen is displayed.
0
The camera recorder is not in the Camera
mode.
Setting the user’s bit
1
Set the [TC DISPLAY] switch on the LCD
monitor to “UB”.
2
Set the [TC GENE.] switch to a setting other
than “REGEN”.
3
Hold down the [MENU] button and press the
[OIS/1] button.
The [UB Preset] setting screen appears.
4
Set the user’s bit (numbers between 0 and
9, or alphabets between A and F).
Use the cross-shaped button (HI) to place the
cursor at the item to set, then use the cross-
shaped button (JK) to change the values.
Memo :
0
Press the [MARKER/2] button to reset each digit to
“0”. The cursor moves to the time digit (left).
5
Check the values and press the Set button
(R).
0
The user’s bit is set and the screen returns
to the normal screen.
0
To cancel the setting, press the [CANCEL]
button.
Caution :
0
When the camera recorder is switched to Media
mode during editing, editing will be canceled
and the screen will close.
0
When editing the user’s bit, the [OIS/1] and
[MARKER/2] button operations that are set in
[Main Menu] B [Camera Function] B [User
Switch Set] are disabled. [MARKER/2] functions
as the number reset button.
(A P111 [User Switch Set Item] )
Setting the User’s Bit
77
Shooting
To Next Page
Loading...
