17
ENGLISH
Other convenient RDS functions and adjustments
Automatic selection of the station when using the number
buttons
Usually when you press the number button, the preset station is tuned in.
However, when the preset station is an RDS station, something different will happen. If the
signals from that preset station are not sufficient for good reception, this unit starts searching
another station broadcasting the same program as the original preset station is broadcasting,
then if any station broadcasting the same program is found, the station will be tuned in.
Changing the display mode while listening to an FM RDS
station
You can change the initial indication on the display to either station name (PS) or to station
frequency, while listening to an FM RDS station.
• See also “Changing the general settings (PSM)” on page 31.
1 Press and hold SEL (Select) for more than 2 seconds so one of the PSM items appears on
the display.
2 Press
¢ or 4 until “TUNER DISP (Display)” appears on the display.
3 Press + / – to select the desired indication (either station name or station frequency).
4 Press SEL again to finish the setting.
Note:
By pressing DISP, you can also change the display while listening to an FM RDS station.
Each time you press the button, the following information appears on upper part of the display:
Then, the display goes back to the original indication in several seconds.
Setting the TA volume level
You can preset the volume level for TA Standby Reception. When a traffic program is received,
the volume level automatically changes to the preset level.
• See also “Changing the general settings (PSM)” on page 31.
1 Press and hold SEL (Select) for more than 2 seconds so that one of the PSM items appears
on the display.
2 Press
¢ or 4 until “TA VOLUME” (with its current setting) appears on the display.
3 Press + / – to set to the desired volume.
4 Press SEL again to finish the setting.
FREQUENCYPS NAME
Station FrequencyPS (Station name) PTY (Program type)
EN11-18.KD-LX3R[E]/f 99.3.9, 6:14 PM17
To Next Page
Loading...
Need help?
General
