49
ENGLISH
To change the display information while tuning into an
ensemble
Normally service name is shown on the upper part of the display.
If you want to check the ensemble name or its frequency, press DISP (Display).
Each time you press the button, the following information appears for a while on the upper
part of the display:
To tune in a particular ensemble without searching:
1 Press FUNC (Function) repeatedly to select the DAB tuner as the source.
2 Press MODE.
3 Press BAND repeatedly to select the DAB band (DAB1, DAB2, or DAB3).
4 Press and hold
¢ or 4
for more than 1 second.
5 Press
¢ or 4
repeatedly until the ensemble you want is reached.
• If you hold down the button, the frequency keeps changing until you release the button.
3
Start searching an ensemble.
When an ensemble is received, searching stops.
To stop searching before an ensemble is
received, press the same button you have
pressed for searching.
4
Select a service you want to listen to.
1 Press MODE.
“MODE” appears on the lower part of the display.
2 Press
¢ or 4
to select a service you want, while “MODE”
is still on the display.
To search
ensembles of higher
frequencies
To search
ensembles of lower
frequencies
1
2
Service name Ensemble name
Frequency
EN48-52.KD-LX3R[E]/f 99.3.9, 6:16 PM49
To Next Page
Loading...
Need help?
General
