11
Overview
Remote control
1. INPUT
Displays the source selection bar.
2. LIGHT
Turns on the remote control backlight for a
few seconds. To keep the backlight on,
press any other key while the backlight is
on. Press the key again to turn the
backlight off.
3. NATURAL
Selects the picture mode: Natural.
4. CINEMA
Selects the picture mode: Cinema.
5. USER1
Selects the picture mode: User 1.
6. USER2
Selects the picture mode: User 2.
7. HIDE
Used to blank the screen picture. Press
most of the keys on the projector or
remote control to restore the picture.
8. OK
Activates the selected On-Screen Display
(OSD) menu item.
9. MENU
Displays the menu, or hides the menu if it is
displayed.
10.BRIGHTNESS
Displays the setting bar for brightness
adjustment.
11. POWER
Toggles the projector between standby mode
and on.
12.DYNAMIC
Selects the picture mode: Dynamic.
13.GAMMA
Displays the Gamma menu.
14.TEST
Displays the test pattern.
15. Right
Activates panel key lock. To unlock the keys,
press and hold for 3 seconds or setting
OSD menu using the remote control.
16.Arrow keys ( Left, Right, Up,
Down)
When the On-Screen Display (OSD) menu is
activated, these keys are used as directional
arrows to select the desired menu items and
to make adjustments.
Launches the Keystone window when the
OSD menu is not activated.
17.BACK
Goes back to previous OSD menu, exits and
saves menu settings.
18.CONTRAST
Displays the setting bar for contrast
adjustment.
1
11
12
13
18
14
17
3
7
9
10
2
5
4
6
8
16
15
To Next Page
Loading...
Need help?
General
