JVC RX-230RBK - Tuning and Radio Features; Tuning Broadcasts; FM Reception Modes

vi-L
Operating the Component
Already Selected
BUA ane «OR Eb
PHONO at » he
TAPE 2
CD Player
CD Player-Changer
ea om a oe)
CO GC CO
Cassette Deck
Turning on the TV or VCR
VCR Li Wie
eas ge ey ON cae
Page 21
Using the Remote Control
By connecting JVC audio components to the COMPU LINK-3 SYNCHRO jacks on the
receiver, you can operate the audio component with this recciver’s remote control. In addition,
if your VCR is a JVC product, you can operate it with this receiver's remote control.
Select a source with the source select buttons on the remote control. Operate that source using
the TAPE J and CD control buttons.
IMPORTANT! if you choose a source directly from the receiver, the remote control
will not operate that source. To operate a source with the remote control, first
select the source using the remote control.
IMPORTANT! When you select CD, TAPE 1, or PHONO on the remote control, the
component will turn on (and start playing automatically if a disc, a cassette tape,
or a record is on the components).
After pressing the CD button, you can perform the following operations with the remote
control:
> Starts playing
hd Returns to the beginning of the current (or previous) track
>>| Goes to the beginning of the next track
a Stops playing
After pressing the CD DISC button on the remote control, you can perform the following
operations on a CD player-changer:
1-6, P Select the number of the disc installed in the CD player-changer.
Then continue to operate the CD player alter pressing the CD button as shown above.
After pressing TAPE | button, you can perform the following operations on the remote control:
Starts playback
Stops operation
Fast wind the tape from right to left
Fast wind the tape from left to right
Sao
Though JVC TV and VCR do not work with the COMPU LINK remote control system, you
can always turn on and off the JVC TV or VCR by pressing the TV ©/| button or VCR (/1
button.
IMPORTANT! Aim the remote control at the TV or VCR, not at the receiver.
Troubleshooting
Use this chart to help you solve everyday operational problems. If there is any problem you
cannot solve, contact your JVC service center.
PROBLEM POSSIBLE CAUSE
SOLUTION
Display is not backlit Power cord not plugged in or
the O POWER switch pressed
out
No sound from speakers Speaker wires not connected
SPEAKERS | and 2 buttons
not set correctly
Incorrect source select button
is pressed
Sound trom one speaker onty Speaker wires not connected
properly
The BALANCE control is set
to one extreme
Continuous hiss or buzzing
during FM reception
Incoming signal is too weak
Station is too far away
Incorrect antenna used
Antenna not connected
properly
Occasional cracking noise
during FM reception
Ignition noise from
automobiles
Howling during record Turntable too close to
playing speakers.
Remote contro! does not There is an obstruction in
work front of the remote sensor
on the receiver
Batteries are weak
Plug power cord into AC outlet
and press in the © POWER
switch
Check speaker wiring and
reconnect if necessary
Press the SPEAKERS § and 2
buttons in or out correctly
Select the correct source
Check speaker wiring and
reconnect if necessary
Adjust the BALANCE control so
that both speakers have equal
sound output
Adjust FM antenna
Select a new station
Check with your dealer to be sure
you have the correct antenna
Check connections
Move the antenna farther from
automobile traffic
Move speakers away from
turntable
Remove the obstruction
Replace batteries
eT
Page 22
MAuYOE?-XY