JVC RX-230RBK - Connecting Audio Components; Stereo Equipment Connections; COMPU LINK-3 System Setup

9-1
COMPU LINK-3
Connecting the Stereo Equipment :
Connections
Before Starting Before connecting the receiver, read the following paragraphs carefully.
IMPORTANT! The left channel] of any audio component must be connect
left-channel jack (marked LEFT) of the receiver, and the right c
channel jack (marked RIGHT). If they are reversed, the stereopk
not be correct.
NOTE: To ensure correct connections, insert the red plug into the right channel, and
the white one into the left channel.
Connect a stereo component to the amplifier using cables with RCA pin plugs. When
connecting to a cassette deck, connect the cassette deck’s output jacks to the amplifier’s jacks
marked IN (PLAY), and the input jacks to those marked OUT (REC).
Basic Connections
NOTE: Any turntables incorporating a small-output cartridge such ay an MC (moving-
coil type) must be connected to this amplifier through a commercial head amplifier
or step-up transformer. Direct connection may result in insufficient volume.
HM 7582 aM _
coax poor y
ANTENNA
uA
To audio
i"
co 3 output
- VIDEO SOUND
To audio output To audio input :
Turntable Cassette deck 2
To audio :
output To audio output
To audio input
CD player Cassette deck 1
NOTES:
¢ Ifa ground cable is provided for your turntable, connect the cable to the GND
terminal of the AM LOOP terminals on the rear panel.
° When you use a cassette deck with COMPU LINK, be sure to connect the TAPE 1
Jacks,
COMPU LINK remote control system connects other JVC audio components with the receiver
to make listening and recording more convenient. To use this system, attach the cables provided
with your JVC components to the COMPU LINK-3 SYNCHRO jacks on the rear panel of the
components. Then connect the cables to the receiver.
NOTES:
* COMPU LINK-3 is an upgraded version of COMPU LINK-1. If your equipment
provides COMPU LINK-1 jacks, you can still connect your equipment, but slight
imperfections may result. Automatic power standby/on, for example, may not
always function properly,
* Refer to page 20 for details about the COMPU LINK remote control system.
IMPORTANT! Do not connect two cassette decks to the COMPU LINK jack
connection may cause the COMPU LINK system to malfunction.
CD player Cassette deck 1
Turntable
Page 6
MaHOee-XY