26
Connection/Installation (TK-C685WPE/TK-C686WPE)
Install the camera with the following procedures.
Preparation (A Page 26)
K
Mounting the camera (A Page 28)
K
Cable Connection (A Page 28)
Setting Up the Wall
1
Make holes in the wall
Make holes (R 45 mm) for the connecting cables to pass
through.
Note :
● Check the strength of the wall. A less firm wall may cause
the unit to fall.
2 Install the anchor bolts for mounting the camera
Install 4 anchor bolts (M8⳯35 mm and above) to mount the
camera.
3 Install the anchor bolt for mounting the fall
prevention wire
Install the anchor bolt to mount the fall prevention wire 30
mm below the center of the upper two anchor bolts that are
used to mount the camera.
4 Pull the cables from the hole in the wall
Pull the power cable, BNC cable, control signal cable and
alarm signal cable from the wall.
Setting Up the Camera
1
Remove the dome cover and take out the cushioning
material
A Loosen the screws (x4) and remove the dome cover
from the camera.
B Remove the cushioning material.
C Remove the tape on the lens section.
D Remove the lens cap.
Camera Installation
Procedures
Mounting the Camera
213
176
60
20
152
126
63
45
12
30
1
2
3
Anchor bolts
to mount the
camera
Anchor bolt to mount the fall
prevention wire
Coaxial cable
Alarm signal cable
Control signal cable
Power cable
Dome Cover
C
D
B
Cushioning
material
Lens cap
Tape
To Next Page
Loading...
