JVC UX-G980V - Recording from a Disc

36
Recording from a Disc
You can record tracks from a disc onto the USB mass
storage class device connected to the USB MEMORY 2
terminal.
• Do not vibrate the System while recording/editing tracks.
Take care especially while “WRITING” is shown on the
display. It may damage the recorded tracks.
Before recording....
• Connect a recordable USB mass storage class device to
the USB MEMORY 2 (
) terminal. (See also page 6.)
• For SVCD/VCD: cancel PBC. (See page 13).
1 Start and stop playback of the disc.
2 Select the first track you want to record.
The System records from the
track to the last.
3 Activate the recording mode.
4 Select a group to record the tracks into.
• If “FORM GRP” is selected, the System will
automatically create the new group. When you want
to create a new group, select “FORM GRP.”
• If you want to give a name to the new group before
recording, see “To Give a Name to New Group” on
page 38.
(on the main unit)
Continued on the next page
To select track mark setting
Only for radio and external component: Select how track
marks are written.
• You can also divide a continuous recording into several
tracks by adding track marks.
1
2 Select a setting.
M. MARK
(Manual Mark)
Track mark is recorded when you
press ENTER/SET while recording.
T. MARK
(Time Mark)
Track mark is recorded every 5
minutes.
A. MARK
(Auto Mark)
Track mark is written when 3-
second interval is detected. (You can
also record track marks by pressing
ENTER/SET.)
(Canceled)
UX-G980V_U.indb 36UX-G980V_U.indb 36 08.9.11 3:28:11 PM08.9.11 3:28:11 PM