EasyManuals Logo

JVC UX-G980V User Manual

JVC UX-G980V
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
59
Troubleshooting
General
Adjustments or settings are suddenly canceled before you
finish.
] There is a time limit. Repeat procedure again.
Operations are disabled.
] The built-in microprocessor may malfunction due to
external electrical interference. Unplug the power cord
and then plug it back in.
Unable to operate the System from the remote control.
] The path between the remote control and the remote
sensor on the System is blocked.
] The batteries are exhausted.
No sound is heard.
] Speaker connections are incorrect or loose.
] Headphones are connected.
No picture appears on the TV screen.
] The video cord connections are incorrect or loose.
No picture is displayed on the TV screen, the picture is
blurred, or the picture is divided into two parts.
] The System is connected to a TV which does not
support progressive video input.
] Incorrect scanning mode is selected (see page 17).
The left and right edges of the picture are missing on the
screen.
] Select “4:3 MULTI LB” for “MONITOR TYPE” (see
page 33).
Radio Operations
Hard to hear broadcasts because of noise.
] Antenna connections are incorrect or loose.
] The AM loop antenna is too close to the System.
] The FM antenna is not properly extended and
positioned.
Maintenance
To get the best performance of the System, keep your discs
and mechanism clean.
Handling Discs
Remove the disc from its case by holding it at the edge
while pressing the center hole lightly.
Do not touch the shiny surface of the disc, or bend the
disc.
Put the disc back in its case after use to prevent warping.
Be careful not to scratch the surface of the disc when
placing it back in its case.
Avoid exposure to direct sunlight, extreme temperature,
and moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center
to edge.
Handling USB mass storage class device
Do not touch the USB connector.
Be careful not to damage the USB connector.
Put the USB connector in the cover or slide in the USB
unit after use to prevent breaking.
Cleaning the System
Stains should be wiped off with a soft cloth. If the System
is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean
with a dry cloth.
Since the System may deteriorate in quality, become
damaged or get its paint peeled off, be careful about the
following:
DO NOT wipe it with a hard cloth.
DO NOT wipe it forcefully.
DO NOT wipe it with thinner or benzine.
DO NOT apply any volatile substance such as
insecticides to it.
DO NOT allow any rubber or plastic to remain in
contact for a long time.
To remove the speaker grilles
Holes Projection
Speaker grille
UX-G980V_U.indb 59UX-G980V_U.indb 59 08.9.11 3:28:58 PM08.9.11 3:28:58 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC UX-G980V and is the answer not in the manual?

JVC UX-G980V Specifications

General IconGeneral
BrandJVC
ModelUX-G980V
CategoryStereo System
LanguageEnglish

Related product manuals